Dynamic analysis of gear rotor system considering shaft bending

Yanan Shi; Fuhao Liu; Chengxiang Hu

doi:10.63313/AERpc.9036

Authors

Yanan Shi Qingdao University of Technology, Qingdao 266000, China Author
Fuhao Liu Qingdao University of Technology, Qingdao 266000, China Author
Chengxiang Hu Qingdao University of Technology, Qingdao 266000, China Author

DOI:

https://doi.org/10.63313/AERpc.9036

Keywords:

Gear system, shaft bending, Dynamic analysis

Abstract

Considering that shaft bending is one of the most common errors in the manu-facturing of gear shaft systems. Therefore, this should be an important consider-ation in the dynamic simulation process. Based on the establishment of the dy-namic model of the spur gear system including shaft bending, the influence of single-bend crankshafts and double-bend crankshafts on the dynamic response of the system was considered. The results show that the greater the degree of shaft bending, the greater the vibration amplitude of the system. Therefore, the degree of shaft bending should be controlled within a reasonable range to pre-vent it from causing instability in the gear system.

References

[1] Genta G. Dynamics of rotating systems. New York: Springer, 2007.

[2] Dimentberg FM. Flexural vibrations of rotating shafts. London: Butterworths, 1961.

[3] Prohl MA. A general method for calculating critical speeds of flexible rotors. J Appl Mech-T ASME 1945; 12: A142–A148.

[4] Lund JW. Stability and damped critical speeds of a flexible rotor in fluid-film bearings. J Manuf Sci Eng 1974; 96: 509–517.

[5] Mitchell LD and Mellen DM. Torsional-lateral coupling in a geared high-speed rotor system. Mech Eng 1975; 97: 95.

[6] Choi ST and Mau SY. Dynamic analysis of geared rotor bearing systems by the transfer matrix method. J Mech Des 2001; 123: 562–568.

[7] Han Q, Zhao J and Chu F. Dynamic analysis of a geared rotor system considering a slant crack on the shaft. J Sound Vib 2012; 331: 5803–5823.

[8] Li M, Hu HY, Jiang PL, et al. Coupled axial-lateral torsional dynamics of a rotor-bearing system geared by spur bevel gears. J Sound Vib 2002; 254: 427–446.

[9] Yang J and Lim TC. Influence of propeller shaft bending vibration on drivetrain gear dy-namics. Int J Auto mot Tech 2015; 16: 57–65.